Las Vegas Powder Coatings Blog
Abrasive Blasting Safety: Silica Dust, Blast Media and What OSHA Requires
Las Vegas, NV · July 1, 2026
Abrasive blasting is one of the most effective ways to strip rust, mill scale and old coatings before a part is finished. It is also a process that throws a lot of fine dust into the air. Depending on the blast media and the surface being blasted, that dust can contain respirable crystalline silica, which OSHA regulates closely.
Why silica dust matters
According to OSHA, breathing respirable crystalline silica can cause silicosis, lung cancer, chronic obstructive pulmonary disease (COPD) and kidney disease. OSHA estimates that about 2.3 million workers in the United States are exposed to silica on the job.
The particles that cause harm are very small, far smaller than the sand you can see, which is why controlling dust at the source matters so much in blasting work.
What the OSHA standard sets
OSHA's general industry silica standard, 29 CFR 1910.1053, sets two key numbers:
- Permissible exposure limit (PEL): 50 micrograms of respirable crystalline silica per cubic meter of air, averaged over an 8-hour day.
- Action level: 25 μg/m³ over an 8-hour day, the point at which employers must begin exposure assessment.
For abrasive blasting specifically, the standard also points employers to OSHA's ventilation requirements for blasting operations (29 CFR 1910.94). It restricts dry sweeping and dry brushing where they could contribute to silica exposure.
The short version
The rules apply to employers and workplaces, but the takeaway is useful for anyone: abrasive blasting belongs in controlled conditions with proper ventilation, respiratory protection and cleanup practices. It is not a casual backyard job.
Blast media choice changes the hazard
OSHA's shipyard guidance on abrasive blasting notes that substitute abrasives such as steel shot, garnet and slags can reduce silica exposure compared with silica sand. It also cautions that some alternatives can raise exposure to other hazardous metals. The safety data sheet (SDS) for any medium should be checked before use.
In other words, there is no single 'safe' medium. The right choice depends on the substrate, the profile needed for the coating, and the contaminants in both the media and the old finish being removed.
Surface prep is still the foundation
None of this changes why blasting matters: a clean, properly profiled surface is what lets a coating bond. You can read more about how preparation affects the finish in our post on powder coating vs. traditional industrial paints, and about the next step in our guide to what salt spray test hours really mean. Our sandblasting services page describes the prep work we offer.
Good coatings start with good prep, and good prep starts with controlling the dust.
Know the medium
Check the SDS for any blast media before use, including for metals other than silica.
Control dust at the source
Ventilation and enclosure matter more than cleanup after the fact.
Skip dry sweeping
OSHA's silica standard restricts dry sweeping where it adds to exposure.
Sources
- OSHA — Silica, Crystalline — health effects and number of exposed workers
- OSHA — 29 CFR 1910.1053, Respirable crystalline silica — PEL, action level, blasting and housekeeping provisions
- OSHA — Shipyard guidance (abrasive blasting) — alternative abrasives and SDS caution
Need parts stripped and prepped?
Tell us about your project and we'll talk through the right preparation for it.


